948TE Automatic Transmission (Service Information): Cover: Installation
- Install NEW
O-ring seals (2) on the transmission wire harness connector socket (1).NOTE:
A light coating of assembly lube can be applied to the O-ring seals (2) to ease installation.
- Place the valve body cover (1) in position on the transmission.
- Insert the wire connector socket (3) into the opening on the inside of valve body (1) with the flat side (2) of the socket on the left.
- Press the wire connector socket (3) inward until the retainer clip groove is exposed on the outside of the valve body cover (1).
- Install the clip (2) to hold the wire connector socket in the valve body cover.NOTE:
The gasket seal and valve body cover pan are replaced together. If either are damaged you must replace the valve body cover pan/gasket as an assembly.
- Make sure the gasket seal is in the groove around the sealing surface of the valve body cover pan.
- Place the transmission pan gasket against the sealing surface of the transmission housing.
- Install the bolts (1) to hold the valve body cover to the transmission housing and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS
.
- Engage the transmission wire connector into the socket on the valve body cover.
- Rotate the lock lever (1) clockwise onto the transmission wire connector.
- If equipped with a diesel engine, install the left side Charge Air Cooler (CAC) hose. Refer to the appropriate service information .
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Fill the transmission, with NEW fluid. Refer to TRANSMISSION FILL .
- Perform the Valve Body Solenoid Learn procedure if the valve body and/or the TCM was replaced during a repair.
- Perform the Transmission Verification Test. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .