Removal And Installation: Removal
WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
HORIZONTAL POSITION
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Position the right rear quarter trim panel aside in the rear enough to gain access to the module. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION
.
- Disconnect the wire harness connectors (2) from the Power LiftGate Module (PLGM) (1).
- Depress the alignment mounting tab (1) and lift up on the that section of the module and pull slightly aft to disengage the rear alignment mounting tabs (2).
- Remove the PLGM from the vehicle.
VERTICAL POSITION
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Position the right rear quarter trim panel aside in the rear enough to gain access to the module. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
- Remove the right rear wheelhouse splash shield. Refer to
SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION
.
- Remove the A/C line to body nut (1).NOTE:
This step is necessary to prevent damage to the A/C lines in Step 7.
- Remove the rear floor distribution duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
- Remove the rear ceiling distribution duct. Refer to DUCT, CEILING DISTRIBUTION, REMOVAL AND INSTALLATION
.
- Remove the two HVAC housing to inner quarter panel bolts (2).
- Carefully Pull the top of rear HVAC housing three inches away from the rear inner quarter panel to gain access to the blower motor fasteners and electrical connector.NOTE:
Extending the HVAC housing greater than three inches from the rear inner quarter panel could result in damage to the A/C lines.
- Disconnect the wire harness connectors (1) from the Power LiftGate Module (PLGM) (2).
- Depress the alignment mounting tab (3) and lift up on the that section of the module and pull slightly aft to disengage the upper alignment mounting tabs.