LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Altitude, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node (Kin) >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

  1. Position the KIN, then install and securely tighten the fasteners.
  2. Connect the KIN wire harness connector.
  3. Install the lower steering column cover and securely tighten the fasteners.
  4. Turn the steering wheel to the middle position and secure it with the position lever.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals