LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Emergency Assistance (EAM) >> Removal And Installation >> Emergency Assistance Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Emergency Assistance Module: Installation

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the EAM to the EAM mounting bracket.
  2. Install and tighten the four screws for the EAM. Tighten the screws securely.
  3. Connect the instrument panel wire harness connectors.
  4. Install the ICS. Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals