LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Security Gateway (SGW) >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If a NEW  Security Gateway Module (SGW) is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

  1. Position the (SGW) to the Instrument Panel (I/P) carrier bracket.
  2. Install the fasteners to secure the (SGW) to the (I/P) carrier bracket.
  3. Connect the wire harness connectors to the (SGW).
  4. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the (IBS) connector.
  6. If a NEW  SGW module is installed, use the diagnostic scan tool to flash the (SGW) module.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals