Programming The Keys/FOBIKS RF-Hub Equipped
This procedure is for Radio Frequency Hub (RF-Hub) equipped vehicles. If the vehicle is not equipped with a RFH. Refer to MODULE, BODY CONTROL (BCM), MODULE PROGRAMMING .
Obtain the vehicle PIN before starting the routine.
Sitting in the vehicle with the doors closed is a requirement for this routine to complete properly.
Do not put a Laptop or other wireless device (cell phone, cell phone, audio device, etc.) on top of or near the center console (between the seats to the dash). The Low Frequency (LF) antenna is below the center console and these devices may interrupt programming. Make sure that the key fob that is being programmed is inside the car away from nearby consumer electronics. Disconnect aftermarket cell phone chargers before attempting to program the key fob.
- Remove all other keyfobs from inside the vehicle, except the keyfob that you want to program to the vehicle.
- Be prepared to press the RKE Unlock button on the keyfob when prompted towards the end of the programming routine.
PROCEDURE
If the vehicle is equipped with a RF-Hub, perform the following procedure to program the keys/fobiks:
- Connect the scan tool.
- Connect and confirm you have a network connection.
- Navigate to RF-Hub and then the "Misc Functions" menu.
- To add a new FOBIK select and perform "Enable Fobiks" and follow the screen prompts to program the keys/fobs to the vehicle.