Radio Receiver With Display Screen Module

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

NOTE:

For RA4 radios, if possible, the version of the map and Point Of Interest (POI) data should be noted before the original radio is replaced with a new unit. If the version of the map and POI data found on the new radio is not equal to or newer than the version that is found, updated data will need to be downloaded and installed to the new radio at the expense of the dealer. For the Navigation system restore and update procedures, refer to NAVIGATION SYSTEM - RESTORE OR UPDATE .

REMOVAL

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL AND INSTALLATION .
Remove the fasteners (1) securing the radio (3) to the instrument panel (2).

Courtesy of CHRYSLER GROUP, LLC
Roll the top of the radio toward the rear of the vehicle and slide the radio (1) out of the instrument panel (2).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the antenna cables and wire harness connectors from the back of the radio.
If equipped, disconnect the USB connector.
Remove the radio (1) from the vehicle.

INSTALLATION

Position the radio (1) to the instrument panel (2).
Connect the wire harness connectors and antenna cables to the radio (1).

Courtesy of CHRYSLER GROUP, LLC
If equipped, connect the USB connector.
Insert the lower side of the radio (1) into the instrument panel (2). Roll the top of the radio (1) to seat the radio in place on the instrument panel (2).
Install the fasteners (1) for the radio (3) and tighten them securely.

Courtesy of CHRYSLER GROUP, LLC
Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

NOTE:
Uconnect® Access Applications and WiFi hotspot will be automatically updated in the replacement radio through the radio's embedded cellular phone based on the customers present subscription status. This update process may take up to an hour, depending upon the number of apps and adequate cellular services accessibility. The dealer is not expected to perform this process or to oversee it, but may need to explain to the vehicle owner or operator that some features and applications may not be fully restored and overall system response may be slowed until the process has completed.

NOTE:
For RA4 radio only: Any factory replacement radio for the same vehicle will be provided with the Navigation system already activated. Refer to the Navigation/Telecommunication information. Refer to DESCRIPTION AND OPERATION .