Diagnostic Test

DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST 

1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. With the scan tool, erase DASM DTCs.
   NOTE:

   In some circumstances, a complete power down is necessary to erase the DTC after is has gone to stored. Turn the ignition off for a minimum of 8 minutes allowing the vehicle to do a complete power down and then erase the DTC.

3. Make sure that all accessories are turned off and that the battery is fully charged.
4. If the DASM was replaced or moved in any way, the DASM must be aligned. Perform the alignment procedure in accordance with the Service Information.
5. Test drive the vehicle and verify proper operation.
6. Using the recorded Environmental Data and the When Monitored Conditions, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.

   Did the DTC return?

   Yes 

   • Repair the DASM DTC(s). Refer to: DRIVERS ASSISTANCE SYSTEM MODULE - DIAGNOSTIC CODE INDEX .

   No 

   • Repair is complete.