Key Fob Programming

NOTE:

Do not put a laptop or other wireless device (cell phone, audio device, etc.) on top of or near the center console (between the seats to the dash). The Low Frequency (LF) antenna is below the center console and these devices may interrupt programming. Verify the key fob that is being programmed is inside the car away from nearby consumer electronics. Disconnect aftermarket cell phone chargers before attempting to program the key fob.

Using Service Library, obtain a Personal Identification Number (PIN) prior to starting the programming routine.

Sitting in the vehicle with the doors closed is a requirement for this routine to complete properly.

When prompted to push button for pairing any button on the key fob must be pressed and released within the requested time.

Using the diagnostic scan tool, select the Radio Frequency (RF) Hub.
Select the "Miscellaneous Functions" tab.
Select and run the "Program Ignition FOBIKs" procedure and follow the screen prompts.

If the key fob fails to program or is inoperative. Refer to DIAGNOSIS AND TESTING .