Wiper Arm: Service and Repair

REMOVAL

1. Before removal check that wiper has stopped at its off position.




2. Remove nut cover and then wiper arm nut.
3. Check that arms are marked "Dr" (Driver Side) and "As" (Passenger Side). If not, mark them before removal.
4. Remove wiper arms.

INSTALLATION

1. Install two bolts on wiper motor and link assembly.
2. Connect wiper motor harness connector.
3. Place cowl vent in position and install nuts and fasteners.
4. Install wiper arms and blades.
5. Check system movement. Wiper arms should stop 1.18 inch (30 mm) (Driver side) and 1.46 inch (37 mm) (Passenger side) from lower windshield edge.