Monitor Scantool Data

Connect scantool to Data Link Connector (DLC).
IG KEY: ON, Engine: OFF
Select Current data mode on the scantool.
Check fuel temperature sensor's value in condition which engine is cool.
1. Specification:
  1. In condition which engine is cool, There is little difference between fuel temperature and outside temperature.
Is a problem found?
YES
1. Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector.
2. Fault was repaired and ECM memory was not cleared.
3. If the problem works out, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
1. Go to "Inspection & Repair" procedure.