Component Inspection

Check IG Failure Sensor 

1. IG KEY: ON, Engine: ON
2. Connect IG failure sensor connector B-12 and ECM connector.
3. Check IG failure sensor's signal on scantool.
   1. Specification: Approx. 0~10V (At idle state)
4. Is IG failure sensor normal?

   YES

   1. IG failure sensor is OK.
   2. Possibility of defective ECM. Temporarily test with a new ECM and check for proper operation.

      If problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO

   1. Test with a new IG failure sensor and check for proper operation. If problem is corrected, replace it.

      And go to "VERIFICATION OF VEHICLE REPAIR " procedure.