Component Inspection

Check FLS 

1. IG KEY: OFF, Engine: OFF
2. Disconnect FLS connector C-06.
3. Check resistance between terminals 1 and 3 of FLS connector when fuel is added or subtracted.
   1. [Specification]
      FLS SPECIFICATIONS CHART
      
      

      FLS	Normal Parameter
      Float position	Full gauge	3/4	1/2	1/4	Empty gauge
      Resistance	8Ω	30Ω	54.5Ω	98Ω	200Ω
      Fuel volume	71.3l	52.5l	37.5l	22.5l	5.6l

      (Above specification's error range is ± 2Ω.)

      Fig 1: Measuring Resistance Between Terminals 1 And 3 Of FLS Connector

      

   Is the FLS normal?

   YES

   1. FLS is OK.
   2. Possibility of defective ECM. Temporarily test with a new ECM and check for proper operation.

   If problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO

   1. Repair or replace it. Then go to "VERIFICATION OF VEHICLE REPAIR " procedure.