Key Teaching Procedures: Notes

The key teaching procedures are done after replacing defective BCM at service station or for providing of additional key(s) to the vehicle owner.

The key teaching procedures are managed by the BCM control unit.

This is the teaching mode used by the dealers in order to replace the BCM and/or the set of keys, or to program additional keys for an existing system.

At service station, the PIN code attached to the vehicle will be communicated to BCM for BCM replacing or additional key teaching. For this purpose, the attached " Vehicle Serial Identification Number" should be sent to After Service Center which office can produce again the " Vehicle secret code" (PIN code), and then with received vehicle secret code (PIN code) the teaching procedure can be carried out.

By writing the PIN code to BCM via Diagnostic tool, the After Market mode teaching starts. With this Diagnostic command, a parameter is set to identify the After Market mode.