LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0335 Crankshaft Position Sensor A Circuit >> Monitor SCANTOOL Data
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Monitor SCANTOOL Data

  1. Connect scantool to DLC (Data Link Cable).
  2. Engine start.
  3. Monitor the "CKP" parameters on the scantool.
    Fig 1: Monitoring CKP Parameter On Scantool
    G04862214Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals