LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0230 Fuel Pump Primary Circuit >> Monitor SCANTOOL Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor SCANTOOL Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Engine start.
  3. Monitor the "Fuel pump relay" parameters on the scantool.
    Fig 1: Monitoring Fuel Pump Relay Parameter On Scantool
    G04862188Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals