LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Front Suspension System) >> Front Strut Assembly >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Strut Assembly: Reassembly

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the spring lower pad (D) so that the protrusions (A) fit in the holes (C) in the spring lower seat (B).
    2. Fig 1: Identifying Protrusions, Spring Lower Seat And Spring Lower Pad
    G04805348Courtesy of KIA MOTORS AMERICA, INC.
  2. Compress coil spring using special tool (09546-26000).

    Install compressed coil spring into shock absorber.

    NOTE:
    1. Indicated two identification color marks on the coil spring one follows model option (see SPECIFICATIONS ) the other follows load classification according to the below.

      Pay attention to distinguish between the two marks and then install them.

    2. Install the coil spring with the identification mark directed toward the knuckle.
  3. After fully extending the piston rod, install the spring upper seat and insulator assembly.
  4. After seating the upper and lower ends of the coil spring (A) in the upper and lower spring seat grooves (B) correctly, tighten new self-locking nut temporarily.
    Fig 2: Identifying Coil Spring And Spring Seat Grooves
    G04805349Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the special tool (09546-26000).
  6. Tighten the self-locking nut to the specified torque.

    Tightening torque: 

    60-70 N.m (6-7 kgf.m, 43.4-50.6 lb-ft)

scientia non olet · About LEMON Manuals