Heater Control Unit Replacement

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Remove the center facia panel (See REPLACEMENT ).
Remove the console upper cover (A).
Disconnect the connector (B).

Fig 1: Identifying Center Cover And Connector
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the air vent mounting screw, then remove the air vent (A).

Fig 2: Identifying Air Vent And Fastener Locations
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the heater control unit mounting screws, then remove the heater control unit (A).

Fig 3: Identifying Heater Control Unit And Screw
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- Make sure the connector (A) is plugged in properly.
Fig 4: Identifying Connector (1 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.

Fig 5: Identifying Connector (2 Of 2)
Courtesy of KIA MOTORS AMERICA, INC.