DTC P0707 Transaxle Range Switch - Low Input: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION AND POSSIBLE CAUSE REFERENCE

Item	Detecting Condition	Possible cause
DTC Strategy	Check for no signal	Open or short in circuit Faulty Shift cable adjustment Faulty Inhibitor switch and Manual control lever position adjustment Faulty TRANSAXLE RANGE SWITCH Faulty TCM (PCM)
Enable Conditions	Engine state = "RUN" 11V ≤ Battery Voltage ≤ 16V TPS ≥ 3%
Threshold value	No signal detected
Diagnostic Time	More than 30seconds
Fail Safe	Recognition as previous signal. When P-D or R-D or D-R SHIFT is detected, it is regarded as N-D or N-R though "N" signal is not detected When sports mode S/W is ON without P,R,N, D-RANGE signals, it is regarded sports mode. (DTC is not set)