Auto Light Sensor: Inspection

While operating the auto light switch, check if the operations are normal as shown in Fig 1.

1. Auto light sensor value is always read at IGN ON.
2. Light is turned ON after 1 second ± 0.1 second when auto light sensor value is same as light ON input value.
3. Light is turned OFF after 2 seconds ± 0.2 second when sensor value is same as light OFF input value.
4. Tail lamp and head lamp are turned ON when sensor value is same as tail lamp ON input value.
5. Light ON value of sensor is based on the TAIL LAMP & HEAD LAMP VOLTAGE SPECIFICATION  table.
6. Head lamp signal is output when head lamp switch is ON. After head lamp is turned OFF, head lamp signal output is immediately stopped if head lamp OFF luminance condition is met at auto light switch ON.
   TAIL LAMP & HEAD LAMP VOLTAGE SPECIFICATION
   
   

   	TAIL LAMP, AV LAMP	HEAD LAMP (low beam)
   ON	1.77V+/-0.08V	0.63V+/-0.06V
   OFF	3.47V+/-0.10V	1.02V+/-0.06V

   NOTE: In the following figure, T1 and T2 is 2 seconds ± 0.2 seconds.
   Fig 1: Identifying Tail Lamp & Head Lamp Voltage Blinking Pattern

   Courtesy of KIA MOTORS AMERICA, INC.