Monitor SCANTOOL Data

IG "OFF" & connect scantool.
ENG "ON" and warm -up the engine to normal operating temperature.
Monitor "TPS" item on the service data.

Fig 1: Scantool Display - Current Data
Courtesy of KIA MOTORS AMERICA, INC.
Is the service data displayed correctly?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NO
1. Go to "TERMINAL AND CONNECTOR INSPECTION " procedure
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?
  YES
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
  NO
  - Go to "POWER CIRCUIT INSPECTION " procedure.