LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2008 >> Rio Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> DTC P0605 Internal Control Module Read Only Memory (ROM) Error >> Monitor Scan Tool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scan Tool Data

  1. Connect scan tool to Data Link Connector (DLC).
  2. Key "ON".
  3. Monitor DTC (Diagnostics Trouble Code) on the scan tool.
    Fig 1: Monitoring DTC (Diagnostics Trouble Code) On Scan Tool
    G04862321Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals