Monitor Scan Tool Data

Connect scan tool to Data Link Connector (DLC).
ENG "ON"
Monitor "Fuel Pump Relay" item on the scan tool.

Fig 1: Scan Tool Display Screen - Fuel Pump Relay
Courtesy of KIA MOTORS AMERICA, INC.
Is the service data displayed correctly?
YES
- Fault is intermittently caused by poor contact in the sensor and/or PCM connector or non cleared PCM memory after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace if necessary and go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.
- In case of open in Main Relay, this DTC can be set. so, check it for open before going next procedure. (Refer to DTC relating to Main relay)