Power Circuit Inspection
- Engine "OFF"
- Disconnect Belt tension sensor connector.
- Ignition "ON" & Engine "OFF".
- Measure voltage between terminal 1 of the Belt tension sensor connector and chassis ground.
Specification : Approx. 5.02V
- Is the measured voltage within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- After repairing open in power circuit or short circuit of belt tension sensor, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute a known-good Belt tension sensor, and check for proper operation.
If the problem is corrected, replace the Belt tension sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.