LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Borrego Limited, 4WD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (SRSCM) >> B1740 P-SIS Front-Driver Short to Ground >> Main harness Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Main harness Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
  3. Disconnect Pressure-Side Impact connector and SRSCM main harness connector.
  4. Measure resistance between terminal "Low" or "High" of the Pressure-Side Impact harness connector and chassis ground.

    Specification :  ∞

  5. Is the measured resistance within specifications?

    YES 

    NO 

    • Substitute the SRSCM main harness and check for proper operation.

      If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals