LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Borrego Limited, 4WD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module (SRSCM) >> B2500 Warning lamp Failure >> Main harness Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Main harness Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.
  3. Disconnect SRSCM main harness connector.
  4. Connect the battery (-) terminal cable to the battery and Ignition "ON" & Engine "OFF".
  5. Measure voltage between Air bag warning lamp terminal of the SRSCM harness connector and chassis ground.

    Specification :  Approx. Batt Voltage

  6. Is the measured resistance within specifications?

    YES 

    • Check warning lamp and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Check airbag fuse, junction block, Warning Lamp, harness between junction block and SRSCM.

      Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NOTE: If you strike or spin the SRSCM at the IG "ON" state, the seat-belt pretensioner, curtain-airbag or side-airbag could be deployed and bring on danger. Handle it with care.
scientia non olet · About LEMON Manuals