Repair Procedures (M5GF2): Installation

Install the cable assembly (A) placing the select and shift lever in neutral position. Refer to INSTALLATION .

Fig 1: Identifying Shift Cable Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Install the retainer (A) and nuts (B).

Fig 2: Identifying Retainer And Nuts
Courtesy of KIA MOTORS AMERICA, INC.
Install the shift lever assembly (A).
TORQUE:

9~14Nm (90~140kgf.cm, 6~9.5lb.ft)

Fig 3: Identifying Shift Lever Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Install the clip (A) connecting the shift cable and the shift lever.

Fig 4: Identifying Clip And Shift Cable
Courtesy of KIA MOTORS AMERICA, INC.
Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.
NOTE: Adjust the slide clip fit into the select lever moving the slide clip in the direction (C).

Fig 5: Identifying Slide Clip And Guide Member
Courtesy of KIA MOTORS AMERICA, INC.
Install the guide member (A) of the select cable (B).

Fig 6: Identifying Guide Member And Cable
Courtesy of KIA MOTORS AMERICA, INC.
Adjust the slide clip (B) to fit it into the select lever pin (A) and install the snap pin (C).
NOTE: Insert the slide clip in the direction as shown in the illustration.
*When Insert the slide clio Transmission and TGS Lever must be in neutral position

Fig 7: Identifying Slide Clip, Lever Pin And Snap Pin
Courtesy of KIA MOTORS AMERICA, INC.
Install the center console (A). Refer to CONSOLE .

Fig 8: Identifying Center Console
Courtesy of KIA MOTORS AMERICA, INC.
Install the shift boot (A).

Fig 9: Identifying Shift Boot

Courtesy of KIA MOTORS AMERICA, INC.