Monitor Scan Tool Data

Connect scan tool to DLC (Data Link Cable).
Warm up the engine to normal operating temperature.
Monitor "IATS" & "ECTS" parameter on scan tool.

Fig 1: Monitoring IATS & ECTS Parameter On Scan Tool
Courtesy of KIA MOTORS AMERICA, INC.
Is the "IATS" & "ECTS" parameter displayed correctly?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- If there is faulty on "ECTS" circuit or itself, check "ECTS" circuit or itself according to the designated "ECTS" troubleshooting guide.
- If there is not faulty on "ECTS" circuit or itself, Go to TERMINAL AND CONNECTOR INSPECTION procedure.