LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2009 >> Rio Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> DTC U0001 Can Communication Bus >> Monitor Scan Tool Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor Scan Tool Data

  1. Connect scan tool to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor the "CAN" parameters on the scan tool.
    • Check the value of current data displayed normally.
    • Check "Transaxle Range Switch" and "Torque Required from TCU" parameters among ECU'S current data. (AT vehicle only)
    • Check "TPS", "RPM", and "Idle Status" parameters among TCU's current data. (AT vehicle only)
    • Check "RPM" and "TPS" parameters among ABS's current data. (ABS or ESP vehicle only)
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals