DTC P0707 Transaxle Range Switch-No Input: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION CHART

Item	Detecting Condition & Fail Safe	Possible cause
DTC Strategy	Check for No signal	Open or short in circuit Faulty TRANSAXLE RANGE SWITCH Faulty PCM
Enable Conditions	Engine speed ≥ 500 RPM OUTPUT SPEED (PG-B) ≥ 0 RPM
Threshold Value	No signal detected
Diagnostic Time	More than 30 sec.
Fail Safe	Recognition as previous signal When P-D or R-D or D-R SHIFT is detected, it is regarded as N-D or N-R though "N" signal is not detected.