DTC P0717 Input Speed Sensor Circuit-No Signal: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION CHART

Item	Detecting Condition & Fail Safe	Possible cause
DTC Strategy	Check voltage range	Signal circuit is open or short Sensor power circuit is open Sensor ground circuit is open Faulty INPUT SPEED SENSOR Faulty PCM
Enable Conditions	Vehicle speed is over 19 Mile/h (30 Km/h) in D,2, L (A/T range switch) Battery voltage > 9V Output speed sensor > 1000 RPM Engine speed (Only 1st gear) > 3000 RPM
Threshold Value	No signal
Diagnostic Time	More than 1sec
Fail Safe	Locked into 3rd or 2nd gear Manual shifting is possible (2nd --> 3rd, 3rd --> 2nd)