Headlamps High Beam Function
- Necessary conditions to switch ON:
- By pushing down the High Beam lever switch if
- the headlamp switch is in position `headlamp Low Beam' or the headlamps Low Beam have been turned ON by the Auto light function.
- By pulling the High Beam lever switch toward the driver (Flash to pass activation)
- By the DRL function activation for Canada.
- Necessary conditions to switch OFF:
- By pulling back the High Beam lever switch (manual reset by the driver) or
- If the headlamps Low Beam are turned OFF or If the Auto light function is active but the Auto light Sensor signal status is not `HL ON') or
- By releasing the Flash To Pass activation and
- If the DRL function is deactivated for Canada.
- Functional diagram
Courtesy of KIA MOTORS AMERICA, INC.