Control Circuit Inspection

Check short in harness
1. IG "OFF".
2. Disconnect Main Relay and ECM connector.
3. Measure resistance between terminal 86 of Main Relay and chassis ground.
4. Measure resistance between terminals 86 and 85 of Main Relay.
  Specification: Infinite
  
  Fig 1: Measuring Resistance Between Terminals 86 And 85 Of Main Relay
  Courtesy of KIA MOTORS AMERICA, INC.
5. Is the measured resistance within specification?
  YES
  - Go to step 2.
  NO
  - Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check open in harness
1. IG "OFF".
2. Disconnect Main Relay and ECM connector.
3. Measure resistance between harness terminal 85 of Main Relay and harness terminal 43 of ECM harness Connector (C144-A).
  Specification: Prix. below 1Ω
  
  Fig 2: Measuring Resistance Between Harness Terminal 85 Of Main Relay And Harness Terminal 43 Of ECM Harness Connector (C144-A)
  Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within specifications?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.