Repair Procedures: Replacement: Notes
- Disconnect the negative (-) battery terminal.
- Remove the crash pad (Refer to CRASH PAD ).
- Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) with bracket (B) located on the cowl cross bar after loosening the bolt and nut.NOTE:
- Punch the shear bolt using a centering punch.
- And drill its head off with a drill bit.
- Be careful not to damage the SMARTRA unit.
- Installation is the reverse of removal procedure.NOTE:
- Tighten the shear bolt until the bolt head break off.