Body Electrical System: Replacement

Disconnect the negative (-) battery terminal.
Remove the third, fourth seat (Refer to SEAT & POWER SEAT )
Remove the D pillar and luggage side trim (Refer to INTERIOR TRIM ).
Use a small screw driver to loosen clip (A). But do not remove power tailgate push rod (B).

Fig 1: Loosening Clip
Courtesy of KIA MOTORS AMERICA, INC.
Remove the power tail gate module mounting bolts (2EA) and connectors (2EA). And then remove the power tail gate module (A).
TORQUE: 0.025 - 0.035 N.m (0.0025 - 0.0035 kg.m)

Fig 2: Identifying Power Tail Gate Module Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal
NOTE:
- Connect the connectors tightly.
- Check the power tail gate for normal operation correctly.
WARNING:
- A lost drive unit mounting bolt in the vehicle may make a noise.
- Don't operate the power tail gate when a push rod is removed.
- A learn cycle must be performed whenever the power is removed.
- Check the normal operating whenever a power tailgate component is removed or replaced. If the chime sound is heard, check the DTC, wiring harness and cable connections.