LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Sedona Base >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch >> Repair procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel (Refer to the CRASH PAD ).
    Fig 1: Identifying Crash Pad Lower Panel
    G06844014Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the screws (2EA) and trip switch connector. Then remove the crash facia panel (B).
    Fig 2: Identifying Crash Facia Panel
    G06844015Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.
    Fig 3: Identifying Ignition Switch
    G06844016Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the door warning switch and key illumination lamp (A) after loosening the screws (B) and disconnecting the 6P connector.
    Fig 4: Identifying Door Warning Switch And Key Illumination Lamp
    G06844017Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the key lock cylinder (C) after pushing lock pin (B) with key ACC.
    Fig 5: Identifying Key Lock Cylinder
    G06844018Courtesy of KIA MOTORS AMERICA, INC.
  7. Installation is the reverse of removal procedure.
scientia non olet · About LEMON Manuals