LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Sedona Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Driver Airbag (DAB) Module and Clock Spring >> Repair procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Installation

  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
    Fig 1: Disconnecting Negative (-) Cable From Battery
    G06838330
  2. Remove ignition key from the vehicle.
  3. Connect the clock spring harness connector and horn harness connector to the clock spring.
  4. Set the clock spring on neutral position and after turning the front wheels to the straight-ahead position, install the clock spring.
  5. Install the steering wheel column cover and the steering wheel.
  6. Connect the Driver Airbag (DAB) module connector and horn connector, then install the Driver Airbag (DAB) module on the steering wheel.
  7. Secure the Driver Airbag (DAB) with the new mounting bolts.

    Tightening Torque (DAB Mounting Bolt)

    : 0.8 ~ 1.1 kgf.m (7.9 ~ 10.8 Nm, 5.8 ~ 8.0 lb.ft)

    Fig 2: Locating DAB Mounting Bolt
    G06838331
  8. Connect the battery negative cable.
  9. After installing the airbag, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    2. Make sure horn button works.
scientia non olet · About LEMON Manuals