Repair procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
Remove the floor console. (Refer to the CONSOLE .)
Pull the lock (1) forward and then pull the lever (3) after pressing the lever lock (2).
Disconnect the airbag system control module connector. (A and B)

Fig 1: Identifying Airbag System Control Module Connectors
Courtesy of HYUNDAI MOTOR CO.
Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove the SRSCM.
CAUTION: You must remove or install SRSCM at the ignition switch OFF because SRSCM has overturn sensing function. SAB, CAB, BPT may be deployed if you shake SRSCM at the direction of up and down or right and left at the ignition switch ON.