Repair Procedures

Inspection

Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.





Lighting switch (Auto Light)





Lighting switch




HS : Head lamp switch(Short inside)

Dimmer And Passing Switch





Turn Signal Switch





Front Fog Lamp Switch





Wiper And Washer Switch Inspection
With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.





Wiper Switch (Intermittent)





Washer Switch





Rear wiper switch





Rear washer switch






Removal

Wiper and Washer Switch
1. Disconnect the negative (-) battery terminal.
2. Remove the steering wheel.

3. Remove the steering column upper (A) and lower (B) shrouds after removing the screw.








4. Disconnect the connector(A). Release the lock of wiper switch using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.





Multifunction Switch Assembly
1. Disconnect the negative (-) battery terminal.
2. Remove the steering wheel.

3. Remove the steering column upper and lower shrouds after removing 3 screws.
4. Remove the clock spring.

5. Disconnect the lighting switch connector and wiper & washer switch connector.
Remove the multifunction switch assembly (A) after loosening 2 mounting screws.






Installation

Multifunction Switch
1. Install the multifunction switch.
2. Install the clock spring.
3. Install the steering column upper and lower shrouds.
4. Install the steering wheel.

NOTE:
Make sure the multifunction switch connectors are plugged in properly.