Ignition Coil: Service and Repair

Removal

1. Disconnect the battery negative terminal.
2. Remove the engine cover.
3. Disconnect the ignition coil connector (A).





NOTE:
- When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).




4. Remove the ignition coil (A).






Installation

1. Install in the reverse order of removal.

Ignition coil installation bolts:9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Inspection

1. Measure the primary coil resistance between terminals (+) and (-).





Standard value:0.75Ohms ± 15%