How To Perform N Position Learning

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.

If the automatic transmission or the TCU is replaced, be sure to initialize the learned values and perform N position learning.

Stop the vehicle by shifting the shift lever to the P range and chock the tires. Turn the ignition switch to the ON position
CAUTION: Check that the vehicle is stationary before operation.
Release the shift lock, and shift the shift lever to the N range.
Check that the TCU N position mark is correct.
Check that the N position is correctly displayed on the High-Scan Pro.
CAUTION:
The command cannot be input unless the ignition switch is on, the shift lever is in the N range, the engine is stopped, and the vehicle speed is 0 km/h.
- Input NG is indicated: Check again that the N position mark is correct. If it is incorrect, adjust it.
- Input OK is indicated: Turn the ignition switch off after releasing the shift lock and shift the shift lever to the P range. Turn the ignition switch on after 5 seconds.
Shift the shift lever from the P to the D position, then check that the indicator displays the correct position.
1. Display is correct: Check the trouble code.
2. Display is incorrect: Perform the initial learning.