Repair Procedures: Reassembly

WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.

Install the front shock absorber to SST (09546-26000).
Assemble the components of the front strut assembly in sequence. (Refer to FRONT STRUT ASSEMBLY components)
After seating the upper and lower ends of the coil spring in the upper and lower spring seat grooves correctly, tighten new self-locking nut.
Tightening torque:

60 ~ 70 N.m (6.0 ~ 7.0 kgf.m, 43 ~ 51 lb-ft)

Fig 1: Identifying Coil Spring
Courtesy of HYUNDAI MOTOR CO.
Install the insulator cap.
Remove the special service tool.