LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2013 >> Soul Base, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Airbag Modules & Clock Spring) >> Side Airbag (SAB) Module >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to install the harness wires not to be pinched or interfered with other parts.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install the new seat back assembly.

    Refer to SEAT .

  4. Install the front seat assembly.

    Refer to SEAT .

  5. Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
  6. Reconnect the battery negative cable.
  7. After installing the Side Airbag (SAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals