Monitor GDS Data: Notes
- Connect GDS to Data Link Connector (DLC).
- IG key "ON", Engine "ON".
- Monitor "Diagnostic Trouble Codes (DTC) " and present of trouble code.
- Are any DTCs present?
Using a GDS, Check if the same DTC resets after clearing DTC.
YES
- Go to "BSD Radar Calibration" procedure.
NO
- Fault is intermittent caused by poor contact in the BSD ECU's connector or was repaired and BSD ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.