Repair Procedures: Replacement

WARNING: This page is about a different car, the 2015 Kia Forte5, 2015 Kia Forte Koup, and 2015 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.

Remove the condenser, and then remove the bottom cap (B) with a L wrench (A) from the condenser.
Tightening Torque:

9.8~14.7 N.m (1.0~1.5 kgf.m, 7.2~10.8lb-ft)

Fig 1: Removing Condenser Bottom Cap Using L Wrench From Condenser
Courtesy of KIA MOTORS AMERICA, INC.
Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.

Fig 2: Condenser Receiver-Drier
Courtesy of KIA MOTORS AMERICA, INC.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.
Install the new bottom cap to the condenser.
NOTE:
- Always replace the receiver-drier and bottom cap at the same time.
- Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
- Be careful not to damage the radiator and condenser fins when installing the condenser.
- Be sure to install the lower mount cushions of condenser securely into the holes.
- Charge the system, and test its performance.