LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2016 >> Forte LX, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Driveshaft Assembly) >> BJ Boot >> Repair Procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2015 Kia Forte5, 2015 Kia Forte Koup, and 2015 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front driveshaft.

    (Refer to "FRONT DRIVESHAFT ")

  2. Remove the TJ joint assembly.

    (Refer to "TJ JOINT ")

  3. Remove the Dynamic damper.

    (Refer to "DYNAMIC DAMPER ")

  4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
    Fig 1: Removing BJ Boot Bands
    G09743458Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the BJ boot.
  6. Install in the reverse order of removal.
    CAUTION:
    • Do not disassemble the BJ assembly.
    • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
    • The boot band should be replaced with a new one.
  7. Check the front alignment.

    (Refer to "FRONT ALIGNMENT ")

scientia non olet · About LEMON Manuals