Repair Procedures: Installation
NOTE:
- Do not use already used injector fixing clip again.
- Install the component to the specified torques.
- Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
- Apply engine oil to the injector O-ring.
- Do not use already used injector O-ring again.
- Do not use already used bolt again.
- When insert the injector, be careful not to damage the injector tip.
NOTE:
- When installing the high pressure fuel pipe and cross over pipe, apply the specified tightening torques with the special service tool (A). [SST No. 09314-3V100]
High Pressure Fuel Pipe Flang Nut:
29.4 ~ 35.3 N.m (3.0 ~ 3.6 kgf.m, 21.7 ~ 26.0 lb-ft)
- Install in the reverse order of removal.