Component Inspection: Notes
WARNING: This page is about a different variant/trim than selected.
- Ignition switch "OFF"
- Disconnect battery (-) cable.
- Refer to "PRESSURE SENSOR CONNECTOR REMOVAL " and disconnect Pressure sensor connector.
- Measure the resistance between each terminal of Pressure sensor harness connector.
Specification: Refer to table below
Terminal Resistance (kΩ) Pin No. 2 (Signal) - Pin No. 3 (Ground) 2.755 ~ 4.133 Pin No. 1 (Power) - Pin No. 3 (Ground) 1.892 ~ 2.838 Pin No. 1 (Power) - Pin No. 2 (Signal) 1.714 ~ 2.838 - Is the measured value within specification?
YES
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace Coupling assembly and then go to "Verification Of Vehicle Repair " procedure.
* In case of Coupling assembly replacement, "Clutch learning Reset" must be performed with GDS. Refer to "Vehicle S/W Management " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace Pressure sensor and then go to "Verification Of Vehicle Repair " procedure.