Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the front seat assembly.
(Refer to "FRONT SEAT ASSEMBLY .")
Push the lock pin (B), remove the front seat headrest (A).

Courtesy of
Remove the front seat lower protector (A).

Courtesy of
Push the lock pins (B) from the front seat back board (A).
CAUTION:
- Push the middle area of clip using the flat head screwdriver.
- Be careful not to damage the lock pins.
Courtesy of

Courtesy of
Disconnect the connectors (A).

Courtesy of
Detach the air ventilation seat back duct (B) by pulling the lock pin (A).

Courtesy of
Pull out the hooks (A) by the front seat back frame.

Courtesy of
Remove the protectors (A) on both sides.

Courtesy of
Turn the front seat back cover inside out. Then pull out the headrest guides (A) while pinching both side of the lower part of the guides, and remove them.

Courtesy of
Remove the front seat back cover (A) from the front seat back frame.

Courtesy of
After removing the velcro tape (A) and hog-ring clips (B) on the front of seat back and remove the front seat back cover (C).

Courtesy of
Install in the reverse order of removal.
Information
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
Courtesy of