Check Injector
- Ignition "OFF".
- Disconnect Injector connector.
- Measure resistance between Pin No. 1 (High) Terminal And Pin No. 2 (Low) terminal of the related Injector. (Component Side)
Specification: 1.18 to 1.31 [20°C (68°F)]
- Is the measured resistance within specification?
YES
- Go to "Verification Of REPAIR " procedure.
NO
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the related Injector and go to "Verification Of REPAIR " procedure.